K8P6415UQB-PI4B

Description

The K8Q2815UQB featuring single 3.0V power supply, is an 128Mbit NOR-type Flash Memory organized as 8M x16. The memory architecture of the device is designed to divide its memory arrays into 284 blocks with independent hardware protection. This block architecture provides highly flexible erase and program capability. The K8Q2815UQB NOR Flash consists of eight banks. This device is capable of reading data from one bank while programming or erasing in the other banks.

The K8Q2815UQB offers fast page access time of 20~30ns with random access time of 60~70ns. The device′s fast access times allow high speed microprocessors to operate without wait states. The device performs a program operation in unit of 16 bits (Word) and erases in units of a block. Single or multiple blocks can be erased. The block erase operation is completed within typically 0.7 sec. The device requires 15mA as program/erase current in the industrial temperature ranges.

The K8Q2815UQB NOR Flash Memory is created by using Samsung's advanced CMOS process technology. This device is available in 56 Pin TSOP package. The device is compatible with EPROM applications to require high-density and costeffective non-volatile read/write storage solutions.

Features

● Core: ARM® 32-bit Cortex™-M0 CPU, frequency up to 48 MHz
● Memories
– 16 to 64 Kbytes of Flash memory
– 4 to 8 Kbytes of SRAM with HW parity checking
● CRC calculation unit
● Reset and power management
– Voltage range: 2.4 V to 3.6 V
– Power-on/Power down reset (POR/PDR)
– Low power modes: Sleep, Stop, Standby
● Clock management
– 4 to 32 MHz crystal oscillator
– 32 kHz oscillator for RTC with calibration
– Internal 8 MHz RC with x6 PLL option
– Internal 40 kHz RC oscillator
● Up to 55 fast I/Os
– All mappable on external interrupt vectors
– Up to 36 I/Os with 5 V tolerant capability
● 5-channel DMA controller
● 1 x 12-bit, 1.0 µs ADC (up to 16 channels)
– Conversion range: 0 to 3.6 V
– Separate analog supply from 2.4 up to 3.6 V
● Up to 10 timers
– One 16-bit 7-channel advanced-control timer for 6 channels PWM output, with deadtime generation and emergency stop
– One 16-bit timer, with up to 4 IC/OC, usable for IR control decoding
– One 16-bit timer, with 2 IC/OC, 1 OCN, deadtime generation and emergency stop
– Two 16-bit timers, each with IC/OC and OCN, deadtime generation, emergency stop and modulator gate for IR control
– One 16-bit timer with 1 IC/OC
– One 16-bit basic timer
– Independent and system watchdog timers
– SysTick timer: 24-bit downcounter
● Calendar RTC with alarm and periodic wakeup from Stop/Standby
● Communication interfaces
– Up to two I2C interfaces: one supporting Fast Mode Plus (1 Mbit/s) with 20 mA current sink
– Up to two USARTs supporting master synchronous SPI and modem control; one with auto baud rate detection
– Up to two SPIs (18 Mbit/s) with 4 to 16 programmable bit frame
● Serial wire debug (SWD)